MP-E6004-UB-4W (special design for separate brake signal "non-stock" wiring). Each kit comes complete with two LED ( Light Emitting Diode ) modules ( one for each side ) special lenses with amber section and electronic flasher module.

All LED super bright technology. This kit differs from our other European kits by working with cars that have been rewired with a separate turn signal and brake light connection. That’s right you don't have to cut holes or add extra light fixtures.  Get brighter safer lighting with an easy install process. We ship worldwide. Lenses included for BOTH sides ( not shown ).

Our NEW improved design works as follows:

1) With brake applied and no turn signal active. Two inner sections light full bright red.

2) With driving lights ON and no turn signal active. Two inner sections light to half bright red.

3) With driving lights OFF and turn signal ON. The outer amber section blinks on/off for turn signal indication.

4) With driving lights ON and turn signal ON. The outer amber section blinks ON/OFF. Two inner sections stay lit to half bright red.

5) With brake applied and turn signal ON. Two inner sections are steady bright red the outer amber section blinks.

6) With the emergency flasher activated the two inner red sections and the yellow section blink on and off.

This kit requires that you drill a small hole in the back of your lamp housing for an extra wire that connects between each lamp housing. These wires are easily added in the trunk of the car and provide perfect operation under all circumstances! If your car is equipped with 4 way or so-called emergency flashers you will need an extra electronic flasher. in emergency mode, all red and amber lights will flash together. Order MP-FLA-CLICK . Front lights will flash at a slower rate than the rear lamps. Purchase MP-1157-UB-DBL to have front lamps flash at a similar rate to rear lamps.